sp
Full Member level 6
- Joined
- Jan 1, 2004
- Messages
- 395
- Helped
- 23
- Reputation
- 46
- Reaction score
- 2
- Trophy points
- 1,298
- Location
- Floating Garden
- Activity points
- 4,044
this is my first time to do my own PCB... i hav few question to ask.... thank you in advance...
i am doing the following circuits design on my PCB board(shown below)
1. what is the stadard width to use? i have no idea, i use all track wth width of 0.8mm, is it ok?
2. for the large current track, wad is the require width for the track? is 0.8mm ok?
3. for ground, i c most PCB use very large width... wad should i use for it? wad is the width to use on GND?
4. any site or resources to look for regarding PCB related topic?
thank you x 56
regards,
sp
i am doing the following circuits design on my PCB board(shown below)
1. what is the stadard width to use? i have no idea, i use all track wth width of 0.8mm, is it ok?
2. for the large current track, wad is the require width for the track? is 0.8mm ok?
3. for ground, i c most PCB use very large width... wad should i use for it? wad is the width to use on GND?
4. any site or resources to look for regarding PCB related topic?
thank you x 56
regards,
sp