I just completed a PCB design and I would like some help verifying my gerber files before sending them to the manufacturer.
I used Eagle for the designing and Gerbv for the simulation. I can't see if there is any error in my design by looking at the .sol
and .cmp files. Is there any other way? I attached my files on the rar file.
Apparently, you didn't manage to setup the layer output correctly. Solder mask and silkscreen layers are O.K., but *.cmp and *.sol signal mayers are messed up.
In the attached file of the first post the .sol and .cmp were exactly the same and they both contained both layers merged.
Now in your picture the .cmp and .sol are shown correctly and each one represents a different layer.
I found my mistake. When I generated the gerb274x files I had the bottom layer both at the .sol and the .cmp files thats why the first image was like that.