Unable to connect at the specified baud rate, Try reducing the baud rate.Reset the hardware into ISP mode again .... (p89v51RD2 )
PROBLEM SOLVED!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Friends this question is asked in MOST of the forum and there is no clear answer given, i too faced the same problem and after so much of attempts, i found that the new flash magic software has some bugs (i guess, but i'm not sure).. so finally i used the older version flash magic i.e------>> Version 2.40 (DLL Version 1.90)... Use this, first time it will ask for reset isp, just press your 8051 reset button and then sucessssssssssssssss with interface
---------- Post added at 22:31 ---------- Previous post was at 22:26 ----------
Unable to connect at the specified baud rate, Try reducing the baud rate.Reset the hardware into ISP mode again .... (p89v51RD2 )
PROBLEM SOLVED!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Friends this question is asked in MOST of the forum and there is no clear answer given, i too faced the same problem and after so much of attempts, i found that the new flash magic software has some bugs (i guess, but i'm not sure).. so finally i used the older version flash magic i.e------>> Version 2.40 (DLL Version 1.90)... Use this, first time it will ask for reset isp, just press your 8051 reset button and then sucessssssssssssssss with interface
Rohith K
+919738606175
:razz: