Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i m using pi exprest tools to desgin a flyback power supply 24 W 24 V 1A-85 VAC 265 VAC.but when i see the output overload power chart ,i find that the power is more than 24 W.
what should i do to limite the power at 24 W when the input voltage change.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.