[SOLVED] orcade error please help

[jtronix]

ERROR(SPMHA1-150): Symbol does not fit into the drawing ... reposition the symbol.

i'm getting above error while placing 1206 package capacitor, due to this i will not able to place part. please help me to solve this problem.

 

[praveenlb]

Change the page size and try.

 

[Ow@i$]

you mean while designing PCB....
increase your board area.... or if size of board is very crucial than try using smaller package like 0805.. or lesser....!!!

 

[sivamani]

u can cross check the symbol origin once.If the origin is too far from the symbol in library then also u will get this issues.move the origin point to center of the component.

 

[jtronix]

origin is in proper place still getting same error. i tried +DB doctor but result was same. ... plz help

 

[sivamani]

then extend the drawing area in design parameters...

go to setup--> design parameters select design tab chnage the size in extents tab....