Orcad capture- off page connector

[Prince Moses]

Hi mate.....

I am using orcad capture for schematic designing.. In that, i need to use off page connector in one of the schematic page.., where i fixed the off page connector part. but i couldnt make to which page it is connected.. just its showing only connector name.. what can i do??? plz help me..

Thank u so much..
yrs..
Prince.

 

[praveenlb]

Hello,
if you use the off page connector you have to give the same net name..in the 2 pages use << symbol out put and >> for input signal..

Regards
Praveen Bhat

 

[NIKHILRAJ]

while placing the offpage connector it will not show the page numbers.
After completing your schematics you have to "annotate" your design for displaying intersheet referance

( tools --> annotate in main window)

 

[Prince Moses]

thank u so much for yr immediate reply mates... thank you..

Regards,
Prince.

 

[Prince Moses]

hi mate..
I placed the off page connectors as u told. then i annotated the schematic pages. Now i got the intersheet ref number for that off page connector.. but, some other hierarchical ports intersheet ref number is missing. What can be the reason for this.??
Thank u so much.

Yrs,
Prince.

 

[NIKHILRAJ]

page number will not display if the ports/offpages are are in same page ( noramally offpages are used to connect between different pages).
Try the setting as shown in the picture and annotate again

 

[Prince Moses]

i got yr point sir.. Now i am able to create the netlist without errors.. thank u so much for yr help sir....

yrs..

Prince Moses, Bangalore