. If you don't do that, you get so weird results like TL13 ( W=890mm L=14mm )
Have you ever seen a Transmission Line with 89cm width, 0.14cm Length ?? You make it short circuit then looking for the error???
Change your mind dear friend. A design engineer must apply "the essentials" then optimize.
You always use "optimization" feature blindly then you ask "where I'm wrong ??"
Before optimizing a system ( any type PA, LNA or others ) you have to have essential knowledge about that system. If you don't do that, you get so weird results like TL13 ( W=890mm L=14mm )
Have you ever seen a Transmission Line with 89cm width, 0.14cm Length ?? You make it short circuit then looking for the error???
Change your mind dear friend. A design engineer must apply "the essentials" then optimize.
. If you don't do that, you get so weird results like TL13 ( W=890mm L=14mm )
Have you ever seen a Transmission Line with 89cm width, 0.14cm Length ?? You make it short circuit then looking for the error???
Change your mind dear friend. A design engineer must apply "the essentials" then optimize.
When I do optimization for S11 and S22, I am getting results nicely without any optimization error. I have attached same results below.
But when I include Pdel_dBm, LS_Gain_dB and dBm(Vout) these for optimization. I included correct measurement equations also. I am getting optimization error.