TUD-yishuihan
Newbie
- Joined
- Dec 1, 2009
- Messages
- 3
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- The Netherland
- Activity points
- 1,312
Hi guys:
anybody has that problem when doing the noise simulation for the equivalent gamma, the value you get is smaller than 2/3?
my value is 0.4~0.6 (UMC 130nm technology, PMOS). this is a very strange value, right? it should not be less than 2/3, because it is the ideal value.
i do not know whether there are some errors of my testbench. my circuit set up is like this: L=360nm,Vdd=1.2, Vgs=0.6 (DC source), Iprobe is used at the drain.
after doing the noise simulation, i use the noise density @20MHz, devided by 4KTgm.
who can figure out where is the problem? or the noise model (BSIM3V3.2.4)used in this technology is not accurate?
thanks in advance
anybody has that problem when doing the noise simulation for the equivalent gamma, the value you get is smaller than 2/3?
my value is 0.4~0.6 (UMC 130nm technology, PMOS). this is a very strange value, right? it should not be less than 2/3, because it is the ideal value.
i do not know whether there are some errors of my testbench. my circuit set up is like this: L=360nm,Vdd=1.2, Vgs=0.6 (DC source), Iprobe is used at the drain.
after doing the noise simulation, i use the noise density @20MHz, devided by 4KTgm.
who can figure out where is the problem? or the noise model (BSIM3V3.2.4)used in this technology is not accurate?
thanks in advance
