Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Oscilloscope problem

Status
Not open for further replies.
A

alyast

Newbie level 3
Newbie level 3
Joined
Dec 16, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,301
Hello. I'm testing MAX4197. I apply sin voltage with amplitude 35mv. MAX4197 should multiply it on 100 on output. Everything works fine on table when we use single bnc oscilloscope cord. But when we put it in vacuum camera it seems that bnc adapter on camera shorten output signal with ground and MAX4197 stop working. Does anybody faced with similar problem? We changed wave impedance of oscilloscope on Mohm in settings. Main problem is that access to camera is restricted in time and everything working without it. How can I quickly determine cause of the problem?
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top