mack369
Newbie level 5
Hello,
I'm working on a layout of device that uses IEEE802.15.4 2.4GHz radio communication.
There is a radio chip with the 50Ohm antenna output and edge PCB mounted SMA connector.
I already used "Wcalc" application to calculate the antenna trace parameters (such width and spacing) but
I'm not sure how should the layout near to SMA connector look like.
I added some examples in attachment, please advice me which way is the best.
I'm working on a layout of device that uses IEEE802.15.4 2.4GHz radio communication.
There is a radio chip with the 50Ohm antenna output and edge PCB mounted SMA connector.
I already used "Wcalc" application to calculate the antenna trace parameters (such width and spacing) but
I'm not sure how should the layout near to SMA connector look like.
I added some examples in attachment, please advice me which way is the best.
Attachments
Last edited: