zezoelec71
Junior Member level 2
hello
I have two c94-m8p board for RTK fixing
one of them is base
the other is the rover
I want to link the rover to Arduino and take the fixed signal
When i link it by UART I can take the GNSS signal without fixing - and when I tried take RTCM signal from radio i cannot take it , itsnot shown
IN the U-Center program the signal is fixed and the rover is in float fixed mode
any advice please .....
thanks in advance
- - - Updated - - -
I modified them from cfg-msg to just send these two signals :
01-3c NAV-RELPSNED
F0-00 NMEA GxGGA
and now I can take these from UART :
µb<($GNGGA,120256.00,3745.93406,N,03231.49743,E,1,09,1.10,1004.6,M,31.6,M,,*7D
ANY ADVICE
I have two c94-m8p board for RTK fixing
one of them is base
the other is the rover
I want to link the rover to Arduino and take the fixed signal
When i link it by UART I can take the GNSS signal without fixing - and when I tried take RTCM signal from radio i cannot take it , itsnot shown
IN the U-Center program the signal is fixed and the rover is in float fixed mode
any advice please .....
thanks in advance
- - - Updated - - -
I modified them from cfg-msg to just send these two signals :
01-3c NAV-RELPSNED
F0-00 NMEA GxGGA
and now I can take these from UART :
µb<($GNGGA,120256.00,3745.93406,N,03231.49743,E,1,09,1.10,1004.6,M,31.6,M,,*7D
ANY ADVICE