if you using allegro 16.2 means
to change the pad stack: click Tools---> pad stack----> modifying design pad stack pad designer window open and change it
for generating Drill Table : manufacturer----> NC---> NC drill and then select (scaling factor is one) auto select tool ---> ok
if you using allegro 16.2 means
to change the pad stack: click Tools---> pad stack----> modifying design pad stack pad designer window open and change it
for generating Drill Table : manufacturer----> NC---> NC drill and then select (scaling factor is one) auto select tool ---> ok
In the Boardstation-Boardstation RE flow you can use the RE environment to do the routing. At the end you have to send the the RE design back to Boardstation.
If you want to change padstacks you have to use Librarian on you'r design. For output you have to use Fablink.
In the Boardstation-Boardstation RE flow you can use the RE environment to do the routing. At the end you have to send the the RE design back to Boardstation.
If you want to change padstacks you have to use Librarian on you'r design. For output you have to use Fablink.
Where I have to generate the Pick N place files.. in expedition pcb we can get it by generating the AIS.. but in board station where I need to go.. Pls help..
I am not able to cross probe the schematic with PCB.. I am using design architect.. could pls help me to make it possible.. Exactly I dont know how to invoke the DA to make it sync with PCB...