Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need help in isochronous data transfer using Cyconsole

Status
Not open for further replies.

itzabhijith

Newbie level 2
Joined
May 19, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
bulk transfer cyconsole

Hi,
I am using Cyconsole to load the firmware into EEPROM.
I have configured the data transfer mode as isochronous.
Version of Cyconsole is 1.7.0.3
But I cannot do data transfer from EZ-USB interface as the Iso Trans button is inactive. I m able to load the the hex file.

Well, I was able to transfer the data from console as Bulk transfer mode.

Which is the latest version available? Am I using the latest version of Cyconsole?
Thanks in advance.
I am using Cypress Chip CY7C68013A
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top