Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Need Help for the Moving Text Display Project

Status
Not open for further replies.

cmyew

Newbie level 5
Newbie level 5
Joined
Aug 28, 2007
Messages
9
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,328
Hello,

I am a newbie in pic microcontroller field. Can somebody provide information about how to scrolling a message by using shift register. the pic that i used is pic16f877a.

the circuit that i used as reference is similiar with the diagram below:
url=http://obrazki.elektroda.pl/14_1194402379.gif]
14_1194402379_thumb.gif
[/url]

i appreciate for ur help

thank you
 

Hello,

Anybody can help me??

Thanks
 
Hi,
It is simple:
Assume i is the numer of the line. Here we have 7 lines.
We usualy start with line 1
1- You select the leds that you wish highligth on line i using serial data transmission since the HC595 is a serial to parallel shifter.
2- This done you, select the the line i in your schematic this choise is done by an 3:8 Encoder.
That mean that PIC must has as output 000.
3- You wait for a while
4- You lowligth the leds
5- You incremente i
6- if i>7 then move to line 1 else move to line i+1 and repeat previous steps.
 

Ahh I see the schematic now, the OP just didn't bother to check his formatting.

Hope they used 0.1uf decoupling caps and a nice big power supply cap. The current needed will be just over 1Amp.
 

See this :

there's a good project on page 11 to download !
 

Hello,

first of all, i really thanks and appreciate for your reply.

But i still confuse at the part of shifting the words from column to next column by using shift register

for example:

10000 01000
10000 01000
10000 -> 01000
10000 01000
10000 01000

thanks
 

Hello Beny,

I also noticed that there have a program that may be suitable for me but i dont have enough point to download it.

Anywhere thanks for your advice
 

if you are using PIC see this

**broken link removed**

it's a good course to start and understand.
 

nobody can help you unless you show the exact schametic.
 

Hello Beny,

thanks for the website that you shared to me. I will try to understand it

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top