Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
But using MMIC amplifier may not be useful due to their high Noise Figure.
Instead of this , you can build transistor amplifer with very low noise in the frequency range 900-2150MHz.
GL
A DVB satellite receiving system starts with an LNB , with about 50 dB gain. The following cable attenuates these signals, and when it is too long you need a satellite line amplifier. So the easily reachable 3 - 4 dB noise figure is more than enough
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.