Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Nc drill problem in board station

Status
Not open for further replies.

arunrajendhar

Member level 3
Joined
Dec 25, 2008
Messages
63
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
India
Activity points
1,630
I have used nc drill spans from 1-2 and 2-3 and 3-6 and I ran the create drill data successfully but the count is wrong and I'm not able to view the drill symbols for these holes..

Kindly help..
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top