Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MWO Microwave Office Tutorial on Optimization

Status
Not open for further replies.

nwittema

Junior Member level 2
Joined
Oct 28, 2008
Messages
24
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Activity points
1,460
microwave office

Hey all,

I am trying to run MWO to optimize some parameters and I was hoping someone might have a tutorial on this to help me do it correctly and alot faster than I have in the past?

I want to optimize Sparameters and VSWR.

Thanks for your help ahead of time!

~Nick
 

Manjunatha_hv

Advanced Member level 3
Joined
Aug 3, 2005
Messages
810
Helped
240
Reputation
480
Reaction score
122
Trophy points
1,323
Location
INDIA
Activity points
8,691
mwo microwave

Hello,

Yes, go through the Getting Started Optimization section, which shows step by step procedure...
www.elec.mq.edu.au/cnerf/resources/GettingStarted.pdf
www.gigacomp.ch/pdfs/Tutorial.pdf
http://www.awr.tv/

It is simple after simulation
1. select the element parameters you want to optimize (if needed constrain limits)
2. Add the VSWR & S-parameter optimizer goals
3. Then go to Simulate => Optimize (leave the deaulft optimizer method & iterations).
4. now you should be able to see the optimized design...!!!

Or upload your MWO project file (*.emp), & VSWR Goals ...I will suggest I how to setup...


---manju---
 

    nwittema

    points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top