Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Multiple lump in HFSS can't sweep

Status
Not open for further replies.
B

baby_1

Advanced Member level 1
Joined
Dec 3, 2010
Messages
415
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Activity points
4,277
Hello
"
The profile cannot be swept, because it has multiple lumps. Only single lump profiles can be swept. (4:36:46 PM Feb 22, 2016) [error] Body could not be created for part Bend1 because of invalid parameters of this part or some of its parent part/coordinate system."

what is my mistake? while I want to sweep a polyline and sirface?
48.JPG
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top