hardik.patel
Member level 5
Hi all,
Here I am working MSP43F5529 Launcpad with CCS.
So in which i am trying to develope code for UARTs..I have successfully written the code for both UART0 and UART1. But somehow both are not working at a same time. (If i disable UART1..then the UART0 will work fine & viceversa.)
Technically i want result as below..
First it should print - "INDIA123456" on UART0 then
"INDIA1234567" on UART1
...........................................................................
But somehow i cant getting as i except
I also tried by changing clock source of boths(inside init_UART0/1 function) as SMCLK & ACLK
but its also not worked. So please I request to see the attached code and guide me.
Here I am working MSP43F5529 Launcpad with CCS.
So in which i am trying to develope code for UARTs..I have successfully written the code for both UART0 and UART1. But somehow both are not working at a same time. (If i disable UART1..then the UART0 will work fine & viceversa.)
Technically i want result as below..
Code:
uart0_send("INDIA123456\r\n"); _delay_cycles(100000); _delay_cycles(100000);
uart_send("INDIA1234567\r\n"); _delay_cycles(100000); _delay_cycles(100000);First it should print - "INDIA123456" on UART0 then
"INDIA1234567" on UART1
...........................................................................
But somehow i cant getting as i except
I also tried by changing clock source of boths(inside init_UART0/1 function) as SMCLK & ACLK
but its also not worked. So please I request to see the attached code and guide me.