Manoni_Lo
Newbie level 5
Hello,
I have to design a sub hz low pass filter according to the technique used in this article:
https://ieeexplore.ieee.org/document/5930351/
I'm simulating it in Cadence. The frequency response is good and the cut-off is at 68 mHz.
I tried to simulate the transient response to an EEG signal and to compare it with an ideal filtering with a low pass filter in Matlab. Is it correct to do that?
The waveform is correct but an additive delay accumulates during time response.
Thank you for your reply
Lorenzo Manoni
I have to design a sub hz low pass filter according to the technique used in this article:
https://ieeexplore.ieee.org/document/5930351/
I'm simulating it in Cadence. The frequency response is good and the cut-off is at 68 mHz.
I tried to simulate the transient response to an EEG signal and to compare it with an ideal filtering with a low pass filter in Matlab. Is it correct to do that?
The waveform is correct but an additive delay accumulates during time response.
Thank you for your reply
Lorenzo Manoni