I am tiring to make a project about SMPS with UC3842 IC. I found a link. please check here.I also found a component for uc3842 of Proteus 8. I draw the same circuit in Proteus 8. But when I run the simulation it does not shows any out put volt.I am attached my project files & screen shot.
1. Screen Shot:
2. Project Files: View attachment US3842-45.rar
If possible please help me on this regards. Once again don't mind for my bad English.
Thank for response. You are right. But I wanted to design SMPS using proteus for understand the simulation. Is there any other way to make a simple SMPS cirute Using proteus?