devmania
Newbie level 4
- Joined
- Aug 23, 2010
- Messages
- 6
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Pune
- Activity points
- 1,336
hello,
i have made an inverter using cd4047 as per the circuit diagram i have uploaded here.. as per the circuit diagram gate pulse are given to the mosfet from pin 10 and pin 11 of the IC . but when i apply 12v to the ic i am getting 12v at pin 10 but not getting any voltage at pin 11 but i am getting 12v from pin 13 so i have connected 100ohm resistor to pin13 . but still i am not getting output from the transformer. i am using a 12-0-12v to 230v center tapped 1.5amp transformer. please tell me where is the fault in my circuit?
i have made an inverter using cd4047 as per the circuit diagram i have uploaded here.. as per the circuit diagram gate pulse are given to the mosfet from pin 10 and pin 11 of the IC . but when i apply 12v to the ic i am getting 12v at pin 10 but not getting any voltage at pin 11 but i am getting 12v from pin 13 so i have connected 100ohm resistor to pin13 . but still i am not getting output from the transformer. i am using a 12-0-12v to 230v center tapped 1.5amp transformer. please tell me where is the fault in my circuit?
