b3l
Newbie level 5
- Joined
- Jun 10, 2011
- Messages
- 8
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Toronto, Canada
- Activity points
- 1,359
Unfortunately I have no information on the LEDs as they were from a surplus store that had no specs for them.
How do I go about adding a wall wart to the IR LED design from the video? It is indeed IR, not just white LED and I don't think I would need anything stronger than what is shown in the video.
My IR LEDs are 5mm transparent light purple and the prongs are bent at a 90 degree angle to the bulb. There are no other markings on them.
---------- Post added at 10:20 ---------- Previous post was at 10:13 ----------
If IR LEDs run on a lower voltage than white LEDs then could I simply swap out the white LEDs for the IR LEDs in a commercially constructed LED light?
My IR LEDs are 5mm transparent light purple and the prongs are bent at a 90 degree angle to the bulb. There are no other markings on them.
bigdogguru, the LEDs I have are 5mm across... is that what you mean or do I need to measure around the bulb.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?