Here is the simulation output. I have not yet built the hardware.
- - - Updated - - -
Updated file. VSx probes added. See the graphs and tell me how to fix the high-side voltage issue.
- - - Updated - - -
Edit 2:
Only getting correct output when dual supply is used for IR2112.
Refer INV-6.2.pdf
Can't the issue be solved without using dual supply for IR2112?
- - - Updated - - -
My conclusion with the circuit analaysis is that the voltage at COM pin of IR2112 should be equal to the GND voltage of Full-Bridge. So, I used -24V.0V for IR2112 COM pin and th eoutput is okay but will the high-side mosfets handle 60V of HOx signals for IRFP064V?
Also, the VSx voltage should swing between +24V and -24V same as Load.
For PWM signal > 50 kHz the output signal is getting distorted and also the HOx and LOx signals. What changes are needed to the circuit to get clean output for 300 kHz PWM?