Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Modelsim vish.exe stopped working

Status
Not open for further replies.

iasongav

Newbie level 1
Newbie level 1
Joined
Feb 17, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
9
Hello,
I have made simple schematic files in xilinx and added a test bench to perform behavioral simulation using modelsim.
Modelsim pe runs fine on his own. When i click on simulate behavioural model on xilinx modelsim opens and vish.exe crash so modelsim stop working.
Do you have any idea why this happens?
If i want to manually run the testbench in modelsim, it compiles but its missing the Unit Under Control as i cannot compile the schematic files.
How is it possible to manually run the testbench?
Thank you
 

This is a good reason to not use the schematic entry in Xilinx ISE. Personally I've never used a schematic for my top level so I can only make a guess that you might be able to export the schematic in Verilog/VHDL. Then you can compile that along with your testbench.

Regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top