Hi,
I am using ModelSim 18.1 for the simulation of my designs. Now the problem is I have some fairly obvious mistakes, and upon compile, ModelSim is skipping them and is not reporting the errors.
did a different error show up a few lines later?
sometimes the error found is not the syntax error you're talking about, but an error as a result of the syntax error.
No, nothing appeared. Basically it is compiling without any error. I don't know why its not detecting errors. It is detecting some other errors, though.
Modules are compiled separately, the error will pop up when you simulate (.e.g module "not bound" error). That's how the simulator works. There will be surely an error message, just read the simulation log thoroughly.
Modules are compiled separately, the error will pop up when you simulate (.e.g module "not bound" error). That's how the simulator works. There will be surely an error message, just read the simulation log thoroughly.