flote21
Advanced Member level 1
Hello guys!
I am working with an old design based on DM385 (Texas Instruments). I have reading all the datasheet and I am the wondering if this part is provided with an on-chipf the termination resistor for MIPI CSI2 receiver interface? As far I could check of this protocol, it is neccesary to add a 100ohm termination resistor between P&N of every channel in the receiver side.
Can anyone hlelp me with this topic, please? I have asked to Texas Instruments and they did not give any clue regarding to this issue:
Greetings
I am working with an old design based on DM385 (Texas Instruments). I have reading all the datasheet and I am the wondering if this part is provided with an on-chipf the termination resistor for MIPI CSI2 receiver interface? As far I could check of this protocol, it is neccesary to add a 100ohm termination resistor between P&N of every channel in the receiver side.
Can anyone hlelp me with this topic, please? I have asked to Texas Instruments and they did not give any clue regarding to this issue:
Greetings