Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microchip MPLAB ICD operation below 4.5V

Status
Not open for further replies.
Z

zekabra

Junior Member level 2
Junior Member level 2
Joined
Jul 2, 2001
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Via Lactea
Activity points
299
Hi,
I am currently designing an application that uses a PIC16LF877 with a VCC of 3.3V. I'm getting some problems using the Microchip debugger as It doesn't recognize the existance of the target microcontroller. I have read the ETN21 technical note from Microchip and replaced R5 as well as R22 and R21, but it still doesn't work properly.

Has anybody had this kind of problem? Any tips?
TIA
 

16F877

Make sure the BOD is disabled (BOD bit=0 in the cinfiguration bits) otherwise the chip will be held in reset below about 4V.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top