Buqpa
Member level 2
meaderline
Hello everybody and thanks in advance for reading this.
I am trying to simulate a Meader-line polarizer, but I'm facing several problems. Due to the nature of the structure (very thing lines in a meander-configuration) using CST means loads of cells for an accurate simulation. I'm using CST 2006 so I can use the unit cell CC, but in that mode no Plane Wave Excitation is posible (or at least that was what I found out).
I also have tried WIPL-D and Ensamble, but I'm afraid I can not get the info I'm looking for - mainly phase and amplitude of the plane wave before and after the polarizer in both parallel and perpendicular components.
Any idea for simulation?
Thanks a lot you all!
Hello everybody and thanks in advance for reading this.
I am trying to simulate a Meader-line polarizer, but I'm facing several problems. Due to the nature of the structure (very thing lines in a meander-configuration) using CST means loads of cells for an accurate simulation. I'm using CST 2006 so I can use the unit cell CC, but in that mode no Plane Wave Excitation is posible (or at least that was what I found out).
I also have tried WIPL-D and Ensamble, but I'm afraid I can not get the info I'm looking for - mainly phase and amplitude of the plane wave before and after the polarizer in both parallel and perpendicular components.
Any idea for simulation?
Thanks a lot you all!