[SOLVED] MAX232 in Proteus simulation - no OUT signal

Status
Not open for further replies.
U

Under89

Newbie level 3
Joined
Nov 11, 2013
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
22
Hi ;-)

I'm trying to make a simulation of the Max232 with ATMega8 in Proteus 7.6.
Circuit diagram shown in the picture



Output signal from the ATMEGA seen on channel A.
Why there is no signal on channel B? (T1OUT)
(Hiddens pins are connected do Vcc(5V) and GND)

Thanks for your help
 
Last edited by a moderator:



I corrected diagram but the problem still exists
 

Project files and .hex with program :wink:
 

Attachments

  • Max232 Atmega8 TEST.rar
    26.9 KB · Views: 108

Hey man out put is coming for your circuit... Please check your software... In my pc the op is coming... The op is amplified inverted input

- - - Updated - - -



SEE THE OP OF UR CIRCUIT
 
Wow
Thank You very much for testing my project. Now i see that i must reinstall Proteus, or install another version.
Fortunately, the problem was solved. Thanks
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…