hareeshP
Member level 3
Hi all,
I'm currently using the MAX 10 (10M02SCU169A7G) for one our project. In MAX 10 (10M0) fpga the pin C4 and C5 are nSTATUS and CONFIG_DONE respectively.
And we have used this pin for some other purpose also. As per the datasheet both these pins are dual purpose pins. When i do the I/O Assignment analysis i am getting the following errors.
In some forums giving solutions like "change the settings of dual purpose pins in the quartus software" but i am not able do this because the window for this settings in quartus software is grayed out (Attaching the screenshot)
I'm currently using the MAX 10 (10M02SCU169A7G) for one our project. In MAX 10 (10M0) fpga the pin C4 and C5 are nSTATUS and CONFIG_DONE respectively.
And we have used this pin for some other purpose also. As per the datasheet both these pins are dual purpose pins. When i do the I/O Assignment analysis i am getting the following errors.
In some forums giving solutions like "change the settings of dual purpose pins in the quartus software" but i am not able do this because the window for this settings in quartus software is grayed out (Attaching the screenshot)