Master MCU (8051) and Slave MCU (8051) sample program

Status
Not open for further replies.

macer_0001

Member level 1
Joined
Aug 15, 2009
Messages
36
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Manila
Activity points
1,491
Is anyone here could help me. I am using 8051 microcontrollers. I read a Mode 3 communication for multicontrollers. But I dont see an example code. Could you give some simple code (assembly language) for master and for slave?

Your support is very much appreciated.

Thank you
 

Refer the page no 17 of this application note for assembly language program of Mode 3 (9 bit) Multiprocessor Communications (Master and Slave).

hope this help

regards
bassa
 
bassa, That information helps me a lot. Thank you for your support.
 

To macer_0001: Thanks for posting the quetion!!!

To Bassa: Thanks for the info! It helped me a lot!
 

wat application ...? i dont find any application here.....

---------- Post added at 22:28 ---------- Previous post was at 22:25 ----------

it would be helpful if get any circuit for this...........
 

wat application ...? i dont find any application here....

any application that required master - slave serial communication

it would be helpful if get any circuit for this...........

There are no specific circuit as such, normally master - slave connection between each master and slave devicess

Refer this lecture notes
**broken link removed**
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…