Master MCU (8051) and Slave MCU (8051) sample program

[macer_0001]

Is anyone here could help me. I am using 8051 microcontrollers. I read a Mode 3 communication for multicontrollers. But I dont see an example code. Could you give some simple code (assembly language) for master and for slave?

Your support is very much appreciated.

Thank you

 

[bassa]

Refer the page no 17 of this application note for assembly language program of Mode 3 (9 bit) Multiprocessor Communications (Master and Slave).

hope this help

regards
bassa

 

[macer_0001]

bassa, That information helps me a lot. Thank you for your support.

 

[gella]

To macer_0001: Thanks for posting the quetion!!!

To Bassa: Thanks for the info! It helped me a lot!

 

[ravirajd7]

wat application ...? i dont find any application here.....

---------- Post added at 22:28 ---------- Previous post was at 22:25 ----------

it would be helpful if get any circuit for this...........

 

[bassa]

wat application ...? i dont find any application here....

any application that required master - slave serial communication

it would be helpful if get any circuit for this...........

There are no specific circuit as such, normally master - slave connection between each master and slave devicess

Refer this lecture notes
**broken link removed**