MASSIVE fluctuation problems

[szczepan]

i got a problem, when i finally finished everything nothing worked i saw that my solder was just touching the neg power to pos power so i de-solder the IC to check if it works but on a 1.5 volt battey i'm getting .8 to 4 to 8 then back to 2, is the chip fried?

 

[awright]

Admittedly I am new to this forum, but I can't find any clue to what IC or circuit or project you are asking about.

 

[szczepan]

oh my bad..the ic7107clp chip, i found out i diagrams shown ho to make it is just a guide line cause you gotta do some tweeks to make it run perfectly but im getting a better results so hopfully its no fried