Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

manual meshing in CST Microwave Studio

Status
Not open for further replies.

JaCot

Newbie level 5
Joined
Dec 7, 2006
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,323
Hi everybody.
I pick two fixpoints and intermidiate them in order to make some parts of my model to be meshed more precisely but the meshing gives no yield - the point is there , but the mesh line is not created.
What do I do incorrect?
Any advise on the manual meshing?
Thanx.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top