Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MAC to MAC connection RGMII

Status
Not open for further replies.
V

VJKris

Member level 1
Member level 1
Joined
Jun 22, 2012
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,530
Hi,

Is it a right way to connect two MAC's TX-->RX in a system(same PCB) directly?
will there any potential issue or it has to be through a PHY?
This is for a switch application of the gigabit interface.

Regards,
VJKris
 

As per me Controller should have Reverse MII interface to interface two MII interfaces.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top