ee484
Full Member level 3
Hi, I am currently using Calibre for my DRC and LVS.
But, in LVS check, I have a components that mismatches properties.
In LVS check, layout (*.gds) VS schematics netlist (not layout netlist vs schematic netlist) I have errors unless I have to make the values in schematic netlist the same as layout (*.gds).
for example, it is supposed to be "250u", but in *.gds file it has "250", which is a several orders of difference in unit.
My question is ..
at the end of taping out, does this will make errors? Or, shall I do layout netlist vs schematic netlist? And, can I trust this layout netlist vs. schematic netlist?
If *.gds file has error, will this be problematic in taping out???
Thanks~
Bee
But, in LVS check, I have a components that mismatches properties.
In LVS check, layout (*.gds) VS schematics netlist (not layout netlist vs schematic netlist) I have errors unless I have to make the values in schematic netlist the same as layout (*.gds).
for example, it is supposed to be "250u", but in *.gds file it has "250", which is a several orders of difference in unit.
My question is ..
at the end of taping out, does this will make errors? Or, shall I do layout netlist vs schematic netlist? And, can I trust this layout netlist vs. schematic netlist?
If *.gds file has error, will this be problematic in taping out???
Thanks~
Bee