juz_ad
Full Member level 2
- Joined
- Dec 17, 2011
- Messages
- 130
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,296
- Activity points
- 2,541
I need to measure the total amount of current being drawn from a voltage source in a circuit simulation.
When I hold the cursor over the voltage source, it turns to the 'current probe' - but the arrow is facing in the 'wrong' direction so I get a negative current draw - as shown in the first screenshot.
If I modify that reading from I[V1] to I[V1]*-1 I get a positive reading - this is the current draw I would expect.
Is this a valid way of getting a correct reading of the total amount of current drawn from a circuit in an LT SPICE sim?
Thanks.
When I hold the cursor over the voltage source, it turns to the 'current probe' - but the arrow is facing in the 'wrong' direction so I get a negative current draw - as shown in the first screenshot.
If I modify that reading from I[V1] to I[V1]*-1 I get a positive reading - this is the current draw I would expect.
Is this a valid way of getting a correct reading of the total amount of current drawn from a circuit in an LT SPICE sim?
Thanks.
