LBdgWgt
Member level 5
Hi all,
i am using phytec-LPC2294 board. I met a very stranget behaviour. With my application, everytime there is an error occur on CAN module which generate an interrupt, the program goes back to reset. i am having problem also to find out the cause because when i put break points in the isr, it doesnt happen.
any idea how to solve it?
thanks,
i am using phytec-LPC2294 board. I met a very stranget behaviour. With my application, everytime there is an error occur on CAN module which generate an interrupt, the program goes back to reset. i am having problem also to find out the cause because when i put break points in the isr, it doesnt happen.
any idea how to solve it?
thanks,