Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Lpc1768 j-link Debug fault

Status
Not open for further replies.
L

lee_lxw

Newbie level 5
Joined
Dec 3, 2012
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,341
When I debug in MDK.
It will "Could not stop Cortex-M3 device， please check the cable"
So I can't continue debug. Why appear this problem?

Thanks!
 
Last edited:

Is the LPC1768 part of a commercial development board or your own design?

What is the current JTAG clock configuration, speed and setting?

Have you disabled any watchdog timers which maybe resetting the device during debugging?


BigDog
 
Okay!
My speed is low. 200KHZ.
Maybe the watchdog! Before I learning the watchdog timer.There is no this fault!
I am going to have a try!
Thanks

- - - Updated - - -

Okay!
My speed is low. 200KHZ.
Maybe the watchdog! Before I learning the watchdog timer.There is no this fault!
I am going to have a try!
Thanks

- - - Updated - - -

Thank you very much!
It is ok now.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top