Mike_wth
Newbie level 2
Hey Guys,
I was searching the internet for a mobile, battery powered touch-display.
Just a tool to run my smartphone on a bigger screen while I'm travelling.
And - Asus just released what I was looking for. The Zenscreen Touch:
A battery powered touchscreen with USB-C and micro HDMI which can even charge a connected Smartphone.
Unfortunately, it is just massive (15.6").
10" to 12" should be the max.
I also found this video, which shows a nice little DIY concept for a simliar solution.
It is not touch, has no battery built in, and the build quality needs some improvements.... but in general it is the right direction.
The guy basically took an old laptop screen, ordered a new controller, added power-in and it runs fine. So far, so simple.
The thing is, when we talk about a touchscreen, based on USB-C which includes a battery, electronics to charge etc etc..... the complexity increases a lot.
To solder some parts together as shown in the video is well within my abilities.
The planning and to find the right parts (if they are even available) is way out of my league.
Therefore, I'm looking for a collaboration.
I can contribute my CAD and 3D-printing skills.
It won't be a big deal to design and print a backplate which provides stability and integrates all boards, cables and the battery seamlessly.
Is anyone out there, who would be interested?
Or does anyone of you have an opinion whether this is feasible at all?
Best Regards
Mike
I was searching the internet for a mobile, battery powered touch-display.
Just a tool to run my smartphone on a bigger screen while I'm travelling.
And - Asus just released what I was looking for. The Zenscreen Touch:
A battery powered touchscreen with USB-C and micro HDMI which can even charge a connected Smartphone.
Unfortunately, it is just massive (15.6").
10" to 12" should be the max.
I also found this video, which shows a nice little DIY concept for a simliar solution.
It is not touch, has no battery built in, and the build quality needs some improvements.... but in general it is the right direction.
The guy basically took an old laptop screen, ordered a new controller, added power-in and it runs fine. So far, so simple.
The thing is, when we talk about a touchscreen, based on USB-C which includes a battery, electronics to charge etc etc..... the complexity increases a lot.
To solder some parts together as shown in the video is well within my abilities.
The planning and to find the right parts (if they are even available) is way out of my league.
Therefore, I'm looking for a collaboration.
I can contribute my CAD and 3D-printing skills.
It won't be a big deal to design and print a backplate which provides stability and integrates all boards, cables and the battery seamlessly.
Is anyone out there, who would be interested?
Or does anyone of you have an opinion whether this is feasible at all?
Best Regards
Mike