Hi,
In this figure the highlighted portion is the transistor footprint. I was able to improve the layout after that to this version. Now following points I need to clear:
You can see the grounds placement; do I simply replace them by “via_gnd”?
Is there any specific way of adding the surrounding conductor layer or is it simply by adding and specifying the dimensions of transmission line? Will I need to change my current layer also?
What would be the sequence of defining layers?
I generate the layout.
Then I change my current layer to vs, via
There I replace my grounds with via_grnd.
Please could you rite in point form all the steps you yourself would take for preparing a perfect layout of an LNA for momentum.
I shall be grateful to you.
Thankyou.