Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dear 7rots51
limiter is my chalenge too.and i gona make it.i think one important point that you have to pay attention is frequency.and the other is your device where limiting take place through that.for example i have seen some waveguide port.maybe you gona make some coaxial one??
ask this question and then we can go ahead step by step
Assuming you have a way of detecting the modulation, a low power oscillator will lock to an incoming signal over a limited bandwidth and thus provide a constant output level. This is useful for FM but not AM.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.