Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

L298 Motor driver problem

Status
Not open for further replies.
K

kunal5959

Junior Member level 3
Junior Member level 3
Joined
Jul 26, 2011
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,644
I bought a L298 Motor driver recently and i am trying to run dc motors using ATMEGA128 MCU. I have a strange problem. Before programming and connecting the MCU. I just connected 11v to the Power supply of the driver and measured the signals .. I see that ENA and ENB are both 5v . IN1......IN4 are 2.5v. All pins used for powering MOTORA and MOTORB are 11V i.e. also the pins meant for GND of Motor is high. all jumpers on the PCB are in place.. This means there is a hardware problem according to me..

Can anyone help me in diagnosing the problem.!

Datasheet:-

**broken link removed**
 

Attachments

  • 20141113_123800.jpg
    20141113_123800.jpg
    2.6 MB · Views: 79

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top