ali107
Newbie level 1
i have a unipolar stepper motor.its specifications are TYPE:23LM-C701-01 , N/P: RH7-1048 04 , 5.2V/PHASE , 1.4 A/PHASE, 1.8 DEG/PHASE...
i have made the l297/l298 stepper motor driver which is shown in the datasheet of l297..
http://www.soiseek.com/STMICROELECTRONICS/L298/
reset=1
clock=PWM
H/F=0
CCW/CW=1
vs=12v
vref=0.5v
Sense resistor=0.5 ohm
but its not working..when i check that l298 gets warm and the motor is not working..can anyone help me with this??..
i have made the l297/l298 stepper motor driver which is shown in the datasheet of l297..
http://www.soiseek.com/STMICROELECTRONICS/L298/
reset=1
clock=PWM
H/F=0
CCW/CW=1
vs=12v
vref=0.5v
Sense resistor=0.5 ohm
but its not working..when i check that l298 gets warm and the motor is not working..can anyone help me with this??..