neddie
Full Member level 5
- Joined
- Feb 23, 2010
- Messages
- 251
- Helped
- 41
- Reputation
- 82
- Reaction score
- 35
- Trophy points
- 1,308
- Location
- South Africa
- Activity points
- 3,026
Hi all.
I'm trying to simulate some lcd drivers in Isis.7
I've done the circuit , using a pic24 and a 2*16 lcd.
If I load the hex file and run the program , it works fine and I get a display on the LCD.
If I load the COF file and run it , it also works , but I am unable to step through source code.
The "debug" window that shows the source code never appears , so I can't see what lines are being
run.
Any ideas?
Cheers
Ned
I'm trying to simulate some lcd drivers in Isis.7
I've done the circuit , using a pic24 and a 2*16 lcd.
If I load the hex file and run the program , it works fine and I get a display on the LCD.
If I load the COF file and run it , it also works , but I am unable to step through source code.
The "debug" window that shows the source code never appears , so I can't see what lines are being
run.
Any ideas?
Cheers
Ned