Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Is it possible to simulate hspice netlist in cadence schematic editor?

Status
Not open for further replies.

dhaval4987

Full Member level 3
Joined
Oct 17, 2009
Messages
161
Helped
12
Reputation
24
Reaction score
12
Trophy points
1,298
Location
AZ
Activity points
2,324
I eventually want to run monte carlo. I know this could be done in HSPICE by synopsys, but I was wondering if it can be done in cadence schematic editor? Coz I think it will be easier for me to do it in tool which is already known rather than learning a new one!
 

You can use HSPICE format netlists of circuit description and device model parameters directly.

But you can not use monte calro description of device model parameters of HSPICE format.

You have to use Spectre format monte calro description of device model parameters.

Do you have Spectre format device model parameters ?
 
Last edited:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top