Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is it possible to design a ramp/sawtooth signal with max038?

Status
Not open for further replies.
M

mengghee

Full Member level 3
Full Member level 3
Joined
Nov 29, 2005
Messages
163
Helped
8
Reputation
16
Reaction score
5
Trophy points
1,298
Location
United Kingdom
Activity points
3,105
Design of Max038

can anybody tell me if it is possible to design a ramp/sawtooth signal with a max038 instead of a triangle signal ? thank you.
 

Design of Max038

Yes. See the product description or datasheet:
**broken link removed**

Basically, you change the triangle's duty cycle to get a sawtooth.
 

    M

    mengghee

    Points: 2
    Helpful Answer Positive Rating
Re: Design of Max038

thank you very much. but i noticed in the datasheet that the maximum duty cycle is only 85%. ideally, i would really like the falling time to be very small. perhaps 99% of duty ratio ? such as the old 8038 IC. so i am wondering if there is anyway i could have use the max038 to subsite the 8038. thank you very much.

regards,
mengghee
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top