tony_lth
Advanced Member level 5
Hi, ALL,
In NCP304 datasheet, the following method make me confused, as the following picture:
It seems the equation for calculated hysteresis is wrong.
I want to adjust hysteresis to more than 1V, say Vth- is 2.7V Vth+ is 3.7V, but the datasheet shows hysteresis only is about 0.35mV change.
What a confusion datasheet.
I checked several version of NCP304 datasheet, and found the same method and the data. So I should be wrong on adjusting hysteresis.
Is it possible to adjust hysteresis of NCP304 to more than 1V?
In NCP304 datasheet, the following method make me confused, as the following picture:
It seems the equation for calculated hysteresis is wrong.
I want to adjust hysteresis to more than 1V, say Vth- is 2.7V Vth+ is 3.7V, but the datasheet shows hysteresis only is about 0.35mV change.
What a confusion datasheet.
I checked several version of NCP304 datasheet, and found the same method and the data. So I should be wrong on adjusting hysteresis.
Is it possible to adjust hysteresis of NCP304 to more than 1V?