amzaiton
Newbie level 3
Hi,
I've designed my IR transmitter as picture attached and assembled the circuit. My input signal is 10V (peak to peak) sine wave and 500KHz frequency. Unfortunately the output signal I got is being clipped at top and bottom end.. I've tried to recalculate the resistor and capacitor value but it gives the same result..
Please help
Thanks
I've designed my IR transmitter as picture attached and assembled the circuit. My input signal is 10V (peak to peak) sine wave and 500KHz frequency. Unfortunately the output signal I got is being clipped at top and bottom end.. I've tried to recalculate the resistor and capacitor value but it gives the same result..
Please help
Thanks